Enabling Interface Admission Bandwidth Limitation

You can use the ip multicast admission-bandwidth-limit command to enable multicast admission control on interfaces (including dynamic IP interfaces) that are configured to run IGMP. You can also use this command on a PIM (sparse-mode, dense-mode, or sparse-dense-mode) interface if IGMP is configured on the interface (including the ip igmp version passive command).

ip multicast admission-bandwidth-limit

• Use to limit bandwidth for an interface that accepts IGMP groups.
• Example

  host1:boston(config-if)#ip multicast admission-bandwidth-limit 2000000

• Use the no version to remove the bandwidth limitation for the interface.
• See ip multicast admission-bandwidth-limit.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.