Setting Statistics Baselines

You can set a statistics baseline for a bridge group (by using the baseline bridge command) or for a bridge interface (by using the baseline bridge interface command).

baseline bridge

• Use to set a statistics baseline for a specified bridge group.
• The router implements the baseline by reading and storing the statistics at the time the baseline is set and then subtracting this baseline whenever baseline-relative statistics are retrieved.
• Example

  host1#baseline bridge westford03

• There is no no version.
• See baseline bridge.

baseline bridge interface

• Use to set a statistics baseline for a particular network interface belonging to a bridge group.
• The router implements the baseline by reading and storing the statistics at the time the baseline is set and then subtracting this baseline whenever baseline-relative statistics are retrieved.
• You must specify the following:
  • interfaceType—One of the following bridge interface types listed in Interface Types and Specifiers in JUNOSe Command Reference Guide:
    • atm
    • fastEthernet
    • gigabitEthernet
    • tenGigabitEthernet
  • interfaceSpecifier—Particular interface; format varies according to interface type; see Interface Types and Specifiers in JUNOSe Command Reference Guide for information
• Example

  host1#baseline bridge interface atm 3/3.1

• There is no no version.
• See baseline bridge interface.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.