Setting Optional Parameters

You can also set the following parameters:

• Set the administrative state of an ATM AAL5 interface to disabled.

  host1(config-if)#atm aal5 shutdown

• Enable CAC on the interface.

  host1(config-if)#atm cac 3000000 ubr 3000

• Configure the clock source.

  host1(config-if)#atm clock internal

• Configure framing on a T3/E3 physical interface.

  host1(config-if)#atm framing g751adm

• Enable ILMI on the interface.

  host1(config-if)#atm ilmi-enable

• Set the ILMI keepalive timer.

  host1(config-if)#atm ilmi-keepalive 5

• Specify the cable length (line build-out) for the ATM interface.

  host1(config-if)#atm lbo long

• Set the administrative state of the ATM interface to disabled.

  host1(config-if)#atm shutdown

• Configure SNMP link status traps on the interface.

  host1(config-if)#atm snmp trap link-status

  host1(config-if)#atm aal5 snmp trap link-status

• Set the operational mode of the physical interface to SDH STM1.

  host1(config-if)#atm sonet stm-1

• Configure the UNI version of ILMI using one of the following methods:
  • Enable auto configuration of ILMI.

    host1(config-if)#atm auto-configuration

  • Set the UNI version that the router uses when ILMI link autodetermination is unsuccessful or ILMI is disabled.

    host1(config-if)#atm uni-version 4.0

• Configure the number of virtual circuits for each virtual path.

  host1(config-if)#atm vc-per-vp 128

• Configure a virtual path tunnel and its traffic parameters.

  host1(config-if)#atm vp-tunnel 2 128

• Enable scrambling of the ATM cell payload on a T3 or an E3 interface.

  host1(config-if)#ds3-scramble

• Set the time interval at which the router records bit and packet rates.

  host1(config-if)#load-interval 90

• Place the interface into loopback mode for router-to-router testing.

  host1(config-if)#loopback diagnostic

• Disable an interface.

  host1(config-if)#shutdown

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.