Example 1: Bridging with Bridged Ethernet

The following example illustrates how to configure transparent bridging with bridged Ethernet.

1. Create the bridge group.

   host1(config)#bridge westford01

2. Create an ATM major interface.

   host1(config)#interface atm 3/3

   
3. Create an ATM 1483 subinterface and associated PVC.

   host1(config-if)#interface atm 3/3.1

   host1(config-subif)#atm pvc 1 0 10 aal5snap

   
4. Specify bridged Ethernet as the encapsulation method on the subinterface. The encapsulation keyword implies that the bridged Ethernet interface is the only interface stacked directly above the ATM 1483 subinterface. As a result, the bridged Ethernet interface cannot have a peer interface stacked above the same lower-layer interface.

   host1(config-subif)#encapsulation bridge1483

   
5. Create a PPPoE major interface over the bridged Ethernet interface. Because this command does not use the encapsulation keyword, the PPPoE interface can have one or more peer interfaces stacked above the same bridged Ethernet interface.

   host1(config-subif)#pppoe

   
6. Configure a subscriber (client) bridge group interface over the bridged Ethernet interface as a peer to the PPPoE interface. Assign the interface to the bridge group you created in Step 1.

   host1(config-subif)#bridge-group westford01

   

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.