[Contents] [Prev] [Next] [Index] [Report an Error]

Equivalent Configuration Example Using IP Subscriber Management

To achieve the same functionality without adversely affecting stateful SRP switchover if it is running on the router, you can issue the following commands to use the subscriber management feature to configure IP subscribers on a dynamic bridged Ethernet interface using RADIUS. In this configuration, the IP service profile provides the subscriber’s authentication parameters, and the subscriber management application is the authenticating layer. To assign the IP service profile to the interface profile, use the bridge1483 service-profile command.



! Define an IP service profile containing the subscriber’s
username, domain, 
and password.
host1(config)#ip service-profile eastServiceProfile 

host1(config-service-profile)#user-name westford001 

host1(config-service-profile)#domain xyzcorp.east 

host1(config-service-profile)#password abc123 

host1(config-service-profile)#exit 

! Configure the interface profile from which to create
a dynamic bridged Ethernet 
! interface. Include the desired attributes (in this case,
IGMP), the name of the 
! route map used to configure the IP subscriber interface
(optional), and the name 
! of the IP service profile containing the authentication
parameters for the dynamic 
! bridged Ethernet interface.
host1(config)#profile east 

host1(config-profile)#ip igmp 

host1(config-profile)#ip igmp immediate-leave 

host1(config-profile)#ip igmp group limit
6 

host1(config-profile)#ip route-map ip-subscriber
eastRouteMap 

host1(config-profile)#bridge1483 service-profile
eastServiceProfile 

host1(config-profile)#exit 

! Configure the static ATM 1483 subinterface to assign
the east profile, 
! enable autodetection of the bridged Ethernet upper-layer
encapsulation type, 
! and define the ATM PVC.
host1(config)#interface atm 2/1.100 point-to-point 

host1(config-subif)#profile bridgedEthernet
east 

host1(config-subif)#auto-configure bridgedEthernet 

host1(config-subif)#atm pvc 100 10 101 aal5snap
6400 0 0 

host1(config-subif)#exit

For more information about using the subscriber management application, see JUNOSe Broadband Access Configuration Guide.

bridge1483 service-profile

Use from Profile Configuration mode to assign the specified IP service profile to the interface profile from which a dynamic bridged Ethernet interface is created.
The IP service profile must be defined in the default virtual router.
Examplehost1(config-profile)#bridge1483 service-profile westServiceProfile
Use the no version to remove the IP service profile assignment from the interface profile.
See bridge1483 service-profile.

[Contents] [Prev] [Next] [Index] [Report an Error]