[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring VLANs over Bridged Ethernet

This section describes how to create the following common static VLAN over bridged Ethernet configurations:

IP over VLAN over bridged Ethernet
PPPoE over VLAN over bridged Ethernet
MPLS over VLAN over bridged Ethernet

You can also configure transparent bridging over VLANs over bridged Ethernet. For information about configuring transparent bridging, see Configuring Bridged Ethernet.

Configuring VLANs over bridged Ethernet interfaces consists of two basic tasks:

Configure the layers up to and including the VLAN subinterface. The steps for this task are common to all configurations.
Configure the higher-level protocols above the VLAN subinterface.

The following sections describe how to configure VLANs over bridged Ethernet. For more information about the commands used in these procedures, see the command descriptions listed in alphabetical order at the end of Configuring Higher-Level Protocols over VLANs.

Note: Before you can remove a VLAN subinterface, you must remove the upper-layer interface stack.

For more information about specifying ATM interfaces and subinterfaces, see Interface Types and Specifiers in JUNOSe Command Reference Guide.

[Contents] [Prev] [Next] [Index] [Report an Error]