[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring Static MLPPP

Static MLPPP configuration consists of two general tasks, each with several subtasks.

To configure static MLPPP:

  1. Create the member links to be aggregated into a multilink bundle.
    1. From Global Configuration mode, specify the individual interface on which you want to configure MLPPP.
      host1(config)#interface serial 2/0:1/1
    2. Specify MLPPP as the encapsulation method on the interface.
      host1(config-if)#encapsulation mlppp
    3. (Optional) Specify the keepalive timeout value for the member link interface.
      host1(config-if)#ppp keepalive 50
    4. (Optional) Specify the authentication method for the member link interface.
      host1(config-if)#ppp authentication pap chap
    5. (Optional) Enable hash-based link selection instead of the default round-robin link selection for the member link interface.
      host1(config-if)#ppp hash-link-selection
  2. Add member links to a multilink bundle.
    1. Define the MLPPP bundle.
      host1(config)#interface mlppp group1
    2. Add each member link.
      host1(config-if)#member-interface serial 2/0:1/1
    3. Assign an IP address to the MLPPP bundle.
      host1(config-if)#ip address 10.10.100.1 255.255.255.0
    4. (Optional) Specify the keepalive timeout value for the MLPPP network interface (the entire MLPPP bundle).
      host1(config-if)#ppp keepalive 50
    5. (Optional) Specify the authentication method for the MLPPP network interface (the entire MLPPP bundle).
      host1(config-if)#ppp authentication pap chap
    6. (Optional) Enable hash-based link selection instead of the default round-robin link selection for the MLPPP network interface (the entire MLPPP bundle).
      host1(config-if)#ppp hash-link-selection
[Contents] [Prev] [Next] [Index] [Report an Error]

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.