[Contents] [Prev] [Next] [Index] [Report an Error]

Configuration Tasks

To configure transparent bridging on an E-series router:

  1. Create a bridge group.
  2. (Optional) Set optional attributes for the bridge group.
  3. Configure bridge group interfaces.
  4. (Optional) Configure nondefault subscriber policies for bridge interfaces.
  5. (Optional) Enable concurrent routing and bridging.
  6. (Optional) If CRB is enabled, configure explicit routing for IP, MPLS, or PPPoE protocols.

The following sections describe how to perform each of these tasks. See Configuration Examples for detailed sample configurations.

Note: For information about the maximum values that the router supports for transparent bridging, see JUNOSe Release Notes, Appendix A, System Maximums.

[Contents] [Prev] [Next] [Index] [Report an Error]

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.