[Contents] [Prev] [Next] [Index] [Report an Error]

Configuration Example Using subscriber Command

The following configuration example illustrates the preceding procedure. The example has two parts:

The first part of the example shows how to use the subscriber command to configure RADIUS authentication for IP subscribers on a dynamic bridged Ethernet interface. This configuration method does not support running stateful SRP switchover on the router.
The second part of the example shows the commands required to re-create this configuration using the IP subscriber management application. This configuration method uses the bridge1483 service-profile command to assign the specified IP service profile to the interface profile, and does support running stateful SRP switchover on the router.

Assume that you have issued the following commands to configure IP subscribers on a dynamic bridged Ethernet interface for RADIUS authentication. In this configuration, the subscriber command provides the subscriber’s authentication parameters, and the static ATM 1483 subinterface is the authenticating layer. Keep in mind that the subscriber command does not support running stateful SRP switchover on the router.



! Configure the interface profile from which to create
a dynamic bridged Ethernet 
! interface. Include the desired attributes (in this case,
IGMP) and, optionally, the 
! name of the route map used to configure the IP subscriber
interface.
host1(config)#profile east 

host1(config-profile)#ip igmp 

host1(config-profile)#ip igmp immediate-leave 

host1(config-profile)#ip igmp group limit
6 

host1(config-profile)#ip route-map ip-subscriber
eastRouteMap 

host1(config-profile)#exit 

! Configure the static ATM 1483 subinterface to assign
the east profile, support 
! RADIUS authentication, enable autodetection of the bridged
Ethernet upper-layer 
! encapsulation type, and define the ATM PVC.
host1(config)#interface atm 2/1.100 point-to-point 

host1(config-subif)#profile bridgedEthernet
east 

host1(config-subif)#subscriber bridgedEthernet
user westford001 

 domain
xyzcorp.east password abc123 

host1(config-subif)#auto-configure bridgedEthernet 

host1(config-subif)#atm pvc 100 10 101 aal5snap
6400 0 0 

host1(config-subif)#exit

[Contents] [Prev] [Next] [Index] [Report an Error]