[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
Before You Configure Transparent Bridging
Before you configure transparent bridging on an
E-series router, verify that:
- You have correctly installed a line module that supports
transparent bridging. For a list of the line modules that support
transparent bridging, see ERX Module Guide, Appendix A, Module Protocol Support or E120 and E320 Module Guide, Appendix A, IOA
Protocol Support for information about the modules that
support transparent bridging.
- Each configured line can transmit data to and receive
data from your switch connections.
Table 23 lists the prerequisite
tasks for configuring transparent bridging and the resources that
you can consult to learn how to perform these tasks.
Table 23: Prerequisite
Tasks for Configuring Transparent Bridging
|
To Learn About
|
See
|
|
Preconfiguration and hardware diagnostic procedures
|
ERX Hardware Guide
E120 and E320 Hardware Guide
|
|
Configuring T3 ATM line modules
|
Chapter Configuring T3 and E3 Interfaces in JUNOSe Physical Layer Configuration Guide
|
|
Configuring OCx/STMx ATM line modules
|
Chapter Configuring Unchannelized OCx/STMx Interfaces
in JUNOSe Physical Layer Configuration Guide
|
|
Configuring Ethernet line modules
|
Chapter Configuring Ethernet Interfaces in JUNOSe Physical Layer Configuration Guide
|
Also have the following information available:
- A diagram of your network topology indicating the names
of the bridge groups and bridge group interfaces that you need to
create
- On ERX-7xx models, ERX-14xx models, and ERX-310 routers,
the slot and port numbers of the line modules over which you want
to configure transparent bridging
- On E120 and E320 routers, slot, adapter, and port numbers
of the IOAs over which you want to configure transparent bridging
- Types and specifiers for the interfaces and subinterfaces
over which you want to create bridge group interfaces
[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
