Defining Aggressive Mode for an IKE Policy Rule

The aggressive-mode command enables aggressive mode negotiation for the tunnel. For additional information about aggressive mode and how it works, see Main Mode and Aggressive Mode .

aggressive-mode

• Use to enable aggressive mode negotiation for the tunnel.
• If you specify aggressive mode negotiation, the tunnel proposes aggressive mode to the peer in connections that the policy initiates.
• If the peer initiates a negotiation, the tunnel accepts the negotiation if the mode matches this policy.
• Use the accepted keyword to accept aggressive mode when proposed by peers
• Use the requested keyword to request aggressive mode when negotiating with peers
• Use the required keyword to only request and accept aggressive mode when negotiating with peers.
• Example

  host1(config-ike-policy)#aggressive-mode accepted

• Use the no version to set the negotiation mode to main mode.
• See aggressive-mode.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.