Creating Dynamic Outside Source Translation Rules

Use the ip nat outside source list command to create a dynamic outside source translation rule. This command dynamically translates outside global source addresses to outside local addresses when packets are routed from the outside network to the inside network (and untranslates the destination address when a packet returns before a translation table entry times out).

The no version of this command removes the dynamic translation rule, but does not remove any previously created translations from the translation table. To remove active translations from the translation table, see Clearing Dynamic Translations.

ip nat outside source list

• Use to create dynamic translation rules that specify when to create a translation for a source address when routing a packet from the outside network to the inside network.
• Example

  host (config) # ip nat outside source list translation1 pool pool1

• Use the no version to remove the dynamic translation rule; this command does not remove any dynamic translations from the translation table.
• See ip nat outside source list.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.