[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring BFD

You configure BFD on routing protocols that use BFD for fast failure detection. BFD does not require any stand-alone configuration; it works in conjunction with the application that it is supporting. Applications on which you configure BFD pass configuration information to BFD when they need fast failure detection.

BFD works with a wide variety of routing protocols. The JUNOSe software currently supports only a few of these protocols. All BFD supported clients provide the ability to configure session parameters for each interface. Refer to the following table for added configuration information:

Configuration Topic	See
EBGP	Chapter Configuring BGP Routing in JUNOSe BGP and MPLS Configuration Guide
IPv4 static routes	Chapter Configuring IP in JUNOSe IP, IPv6, and IGP Configuration Guide
IS-IS	Chapter Configuring IS-IS in JUNOSe IP, IPv6, and IGP Configuration Guide
OSPF	Chapter Configuring OSPF in JUNOSe IP, IPv6, and IGP Configuration Guide
OSPFv3	Chapter Configuring OSPF in JUNOSe IP, IPv6, and IGP Configuration Guide
PIM	Chapter Configuring PIM for IPv4 Multicast in JUNOSe IP, IPv6, and IGP Configuration Guide and chapter Configuring PIM for IPv6 Multicast in JUNOSe Multicast Routing Configuration Guide
RIP	Chapter Configuring RIP in JUNOSe IP, IPv6, and IGP Configuration Guide
RSVP-TE	Chapter Configuring MPLS in JUNOSe BGP and MPLS Configuration Guide

[Contents] [Prev] [Next] [Index] [Report an Error]