Setting the Receiving Interface

When you configure multiple RTR entries to use the same target address, you must issue the receive-interface command to set the interface on which the probe expects to receive responses. This action enables the router to map incoming responses to the proper RTR entry, even when multiple RTR entries have the same target address.

receive-interface

• Use to specify the interface on which the RTR probe expects to receive responses.
• You must set this attribute when multiple RTR entries are configured to use the same target address.
• Example

  host1(config-rtr)#receive-interface fastEthernet 3/0

• Use the no version to restore the default value, which is to receive a response on any interface.
• See receive-interface

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.