[Contents] [Prev] [Next] [Index] [Report an Error]

Monitoring RIP

Two sets of commands enable you to monitor RIP operation on your router: the debug and the show commands. Both sets of commands provide information about your router’s RIP state and configuration.

The task you are performing with each of these monitoring commands is basically the same for each command; that is, you are requesting information. The results of this request may vary. For instance, the debug commands provide information about problems with the network or the router, whereas the show commands provide information about the actual state and configuration of your router.

[Contents] [Prev] [Next] [Index] [Report an Error]