debug Commands

The debug commands provide information about the following RIP items:

• General events, such as creating a RIP process or removing RIP from an interface
• Routing events, such as when two RIP routers exchange routes

debug ip rip

• Use to display information about selected RIP events. This command has many keywords that allow you to specify a variety of RIP events.
• You can set the level of severity for the events you want displayed; specify the desired descriptive term or a corresponding number (0–7).
• You can set the verbosity of the messages you want displayed: low, medium, high.
• Example

  host1#debug ip rip events

• Use the no version to cancel the display of any information about the designated variable.
• See debug ip rip

undebug ip rip

• Use to cancel the display of information about a selected event.
• The same RIP variables can be designated as in the debug ip rip command.
• Example

  host1#undebug ip rip events

• There is no no version.
• See undebug ip rip

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.