[Contents] [Prev] [Next] [Index] [Report an Error]

Before You Configure IPv6

Before you configure IPv6, you must create the lower-layer interfaces over which IPv6 traffic flows. In this release, the following modules support IPv6 configuration:

ATM OC3/STM-1
ATM OC12/STM-4
Fast Ethernet (FE-8)
Gigabit Ethernet (GE)
10-Gigabit Ethernet (10GE)
OC48 POS (PPP only)

For example, to configure an ATM interface:



host1(config)#interface atm 1/0 

host1(config-if)#atm sonet stm-1 

host1(config-if)#no loopback 

host1(config-if)#atm clock internal chassis 

host1(config-if)#interface atm 1/0.10 

host1(config-if)#atm pvc 10 0 20 aal5snap

See JUNOSe Link Layer Configuration Guide for information about configuring an ATM interface. See JUNOSe Physical Layer Configuration Guide for information about configuring an Ethernet interface.

[Contents] [Prev] [Next] [Index] [Report an Error]