MPLS Interface Configuration Tasks

These tasks are performed at the major interface over which you want to run MPLS. Creating or accessing an interface places the CLI in Interface Configuration mode. You can then configure MPLS options on that interface. The following sequence is arbitrary; you can perform these tasks in any order.

Note: Loop detection is always enabled in the JUNOSe MPLS implementation.

Your choice of label distribution protocol determines whether the LDP or RSVP-TE interface configuration tasks are appropriate for your network design.

MPLS interface configuration tasks include the following sets of tasks:

•  MPLS Interface Tasks
•  LDP Interface Tasks
•  RSVP-TE Interface Tasks

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.