Configuring Layer 2 Services over MPLS

This chapter describes how to configure layer 2 services over MPLS on the router, and contains the following sections:

• Before You Configure Layer 2 Services over MPLS
• Configuring Frame Relay Layer 2 Services
• Configuring Interoperation with Legacy Frame Relay Layer 2 Services
• Configuring Ethernet/VLAN Layer 2 Services
• Configuring S-VLAN Tunnels for Layer 2 Services
• Configuring Local Cross-Connects Between Ethernet/VLAN Interfaces
• Configuring Local ATM Cross-Connects with AAL5 Encapsulation
• Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation
• Configuring HDLC Layer 2 Services
• Configuring CE-Side Load Balancing for Martini Layer 2 Transport
• Frame Relay over MPLS Configuration Example
• MPLS L2VPN Tunnel over VLAN over LAG Configuration Example
• MPLS L2VPN Tunnel over LAG Configuration Example
• Ethernet Raw Mode Encapsulation for Martini Layer 2 Transport Examples
• S-VLAN Subinterface with an Untagged C-VLAN ID Examples

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.