[Contents] [Prev] [Next] [Index] [Report an Error]
Configuration on PE2 (Remote PE Router)

Use the following commands on the remote PE router (PE2) to configure the MPLS L2VPN tunnel shown inFigure 122.


! Configure a virtual router PE2.
host1(config)#virtual-router pe1 

!
! Enable MPLS on a virtual router in Global Configuration
mode.
host1:pe2(config)#mpls .
!
! Configure PE2 to create topology-driven LSPs. Enabling
LDP automatically creates  
! topology-driven LSPs.
host1:pe2(config)#mpls topology-driven-lsp

!
! On PE2, configure a loopback interface, and assign an
IP address and mask to  
! the interface. 
host1:pe2(config)#interface loopback 0 

host1:pe2(config-if)#ip address 22.22.22.22
255.255.255.255 

!
! Assign the router ID using the IP address you configured
for the loopback 
! interface.
host1:pe1(config)#ip router-id 22.22.22.22 

!
! Create a Gigabit Ethernet interface and configure MPLS
tunneling with the IP  
! address of the router on the remote end of the layer
2 circuit and the virtual  
! circuit identifier.
host1:pe2(config)#interface gigabitEthernet
2/1/6 

host1:pe2(config-if)#encapsulation vlan

!
! Create a VLAN subinterface by adding a subinterface number
to the interface  
! identification command. Assign an S-VLAN ID and a VLAN
ID for the subinterface. 
! Also, configure MPLS tunneling.
host1:pe2(config-if)#interface gigabitEthernet
2/1/6.1 

host1:pe2(config-subif)#svlan id 1 1 

host1:pe2(config-subif)#mpls-relay 11.11.11.11
1

!
! Create a Gigabit Ethernet interface on PE2 and specify
VLAN as the  
! encapsulation method.
host1:pe2(config)#interface gigabitEthernet
2/1/5 

host1:pe2(config-if)#encapsulation vlan

!
! Create another Gigabit Ethernet subinterface on the main
interface. For this  
! interface, assign a VLAN ID, specify the encapsulation
method as VLAN, configure  
! MPLS, and assign an IP address and mask. Also, enable
LDP and topology-driven  
! LSP, as does any LDP-related command, using an implicit
default profile, on this  
! Gigabit Ethernet subinterface.
host1:pe2(config-if)#interface gigabitEthernet
2/1/5.1 

host1:pe2(config-subif)#vlan id 20 

host1:pe2(config-subif)#ip address 2.0.0.2
255.255.255.0 

host1:pe2(config-subif)#mpls 

host1:pe2(config-subif)#mpls ldp

!
! Configure a static route with the destination IP address,
mask, and IP address of  
! the next hop that can be used to reach the destination
network. 
host1:pe2(config)#ip route 22.22.22.22 255.255.255.255
2.0.0.1 

! 
! Configure LDP to advertise a non-null label for the egress
routes. 
host1:pe2(config)#mpls ldp egress-label non-null
[Contents] [Prev] [Next] [Index] [Report an Error]