[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
Configuration on PE 2 (Remote PE Router)
Use the following commands on the remote PE router
(PE 2) to configure the VPLS topology shown in Figure 129.
- ! Configure VPLS instance vplsA.
- host2(config)#bridge vplsA vpls transport-virtual-router
default
- !
- ! Configure VPLS instance vplsB.
- host2(config)#bridge vplsB vpls transport-virtual-router
default
- !
- ! Configure Fast Ethernet interface 2/5 between PE 2 and
CE 3,
- ! and assign it to vplsA as a trunk interface.
- host2(config)#interface fastEthernet 2/5
- host2(config-if)#bridge-group vplsA subscriber-trunk
- host2(config-if)#exit
- !
- ! Configure bridged Ethernet interface 6/0.21 between PE
2 and CE 4,
- ! and assign it to vplsB as a trunk interface.
- host2(config)#interface atm 6/0.21 point-to-point
- host2(config-subif)#atm pvc 21 0 21 aal5snap
0 0 0
- host2(config-subif)#encapsulation bridge1483
mac-address 0090.1a40.9992
- host2(config-subif)#bridge-group vplsB subscriber-trunk
- host2(config-if)#exit
- !
- ! Configure LDP signaling for vplsA.
- host2(config)#mpls ldp vpls vplsA vpls-id
1
- host2(config)#mpls ldp vpls vplsA neighbor
1.1.1.1
- !
- ! Configure LDP signaling for vplsB.
- host2(config)#mpls ldp vpls vplsB vpls-id
2
- host2(config)#mpls ldp vpls vplsB neighbor
1.1.1.1
- !
- ! Configure a loopback interface on PE 2 and assign it
an IP address.
- host2(config)#interface loopback 0
- host2(config-if)#ip address 2.2.2.2 255.255.255.255
- host2(config-if)#exit
- !
- ! Assign the router ID for PE 2 using the IP address of
the loopback interface.
- host2(config)#ip router-id 2.2.2.2
- !
- ! Configure ATM core-facing interface 6/1.20 between PE
2 and the P router,
- ! and assign it an IP address.
- host2(config)#interface atm 6/1.20 point-to-point
- host2(config-subif)#atm pvc 20 0 20 aal5snap
0 0 0
- host2(config-subif)#ip address 20.20.20.2
255.255.255.0
- !
- ! Enable MPLS, LDP, and topology-driven LSPs on the core-facing
interface.
- host2(config-subif)#mpls
- host2(config-subif)#mpls ldp
- host2(config-subif)#exit
- !
- ! Configure OSPF routing in the core MPLS network.
- host2(config)#router ospf 1
- host2(config-router)#network 2.2.2.2 0.0.0.0
area 0.0.0.0
- host2(config-router)#network 20.20.20.0 0.0.0.255
area 0.0.0.0
- host2(config-router)#exit
Related Topics
[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
