 |
Note: The bridge vpls site-range command is available for a VPLS instance only after you issue the bridge vpls transport-virtual-router command, which creates the VPLS instance and configures the transport virtual router. |
bridge vplsName vpls site-range siteRange
no bridge vplsName vpls site-range
Command introduced in JUNOSe Release 7.1.0.
Configures the maximum number of customer sites that can participate in the specified VPLS domain that uses BGP as the signaling protocol. In a VPLS configuration, each customer site is represented by a customer edge (CE) device located at the edge of the customer's network. The router (VPLS edge device) communicates with the customer site by means of a bridge network interface connection to the CE device. The no version restores the default site range, 1.
The bridge vpls site-range command is not valid for a VPLS instance that uses LDP as the signaling protocol. To configure a VPLS instance with LDP signaling, use the mpls ldp vpls vpls-id command and the mpls ldp vpls neighbor command.
|
Note: The bridge vpls site-range command is available for a VPLS instance only after you issue the bridge vpls transport-virtual-router command, which creates the VPLS instance and configures the transport virtual router. |
Global Configuration
 | Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |