[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
Supported RADIUS IETF Attributes
Table 34 lists the Access-Request,
Access-Accept, Access-Reject, Access-Challenge, CoA, and Disconnect-Request
attributes supported by JUNOSe software. The following notes are referenced
in Table 34:
- Attribute is used by Access-Request messages
when terminating a PPP connection at the LNS or the initiating LAC.
- Attribute is used to support pass-through
exchange of EAP messages.
- Attribute is used by Access-Challenge messages
to set the PPP retransmission timeout used for EAP request packets.
Table 34 lists the RADIUS
IETF attributes supported for Access-Request, Access-Accept, Access-Reject,
CoA-Request, and Disconnect-Request messages.
Table 34: AAA Access
Message RADIUS IETF Attributes Supported
|
Attribute Number
|
Attribute Name
|
Access- Request
|
Access- Accept
|
Access- Reject
|
Access-
Challenge
|
CoA-
Request
|
Disconnect-
Request
|
|
[1]
|
User-Name
|
✓
|
✓
|
–
|
–
|
✓
|
✓
|
|
[2]
|
User-Password
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[3]
|
CHAP-Password
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[4]
|
NAS-IP-Address
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[5]
|
NAS-Port
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[6]
|
Service-Type
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[7]
|
Framed-Protocol
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[8]
|
Framed-IP-Address
|
✓
|
✓
|
–
|
–
|
✓
|
–
|
|
[9]
|
Framed-IP-Netmask
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[11]
|
Filter-Id
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[12]
|
Framed-MTU
(See Note 2.)
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[18]
|
Reply-Message
(See Note 2.)
|
–
|
✓
|
✓
|
✓
|
–
|
–
|
|
[22]
|
Framed-Route
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[24]
|
State
(See Note 2.)
|
–
|
–
|
✓
|
✓
|
–
|
–
|
|
[25]
|
Class
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[27]
|
Session-Timeout
(See Note 2.)
(See Note 3.)
|
–
|
✓
|
✓
|
✓
|
–
|
–
|
|
[28]
|
Idle-Timeout
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[30]
|
Called-Station-Id
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[31]
|
Calling-Station-Id
|
✓
|
–
|
–
|
–
|
✓
|
–
|
|
[32]
|
NAS-Identifier
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[33]
|
Proxy-State
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[44]
|
Acct-Session-Id
|
✓
|
–
|
–
|
–
|
✓
|
–
|
|
[50]
|
Acct-Multi-Session-Id
|
✓
|
–
|
–
|
–
|
–
|
✓
|
|
[60]
|
CHAP-Challenge
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[61]
|
NAS-Port-Type
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[62]
|
Port-Limit
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[64]
|
Tunnel-Type
(See Note 1.)
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[65]
|
Tunnel-Medium-Type
(See Note 1.)
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[66]
|
Tunnel-Client-Endpoint
(See Note 1.)
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[67]
|
Tunnel-Server-Endpoint
(See Note 1.)
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[68]
|
Acct-Tunnel-Connection
(See Note 1.)
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[69]
|
Tunnel-Password
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[77]
|
Connect-Info
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[79]
|
EAP-Message
(See Note 2.)
|
✓
|
✓
|
✓
|
✓
|
–
|
–
|
|
[80]
|
Message-Authenticator
(See Note 2.)
|
✓
|
✓
|
✓
|
✓
|
–
|
–
|
|
[82]
|
Tunnel-Assignment-Id
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[83]
|
Tunnel-Preference
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[85]
|
Acct-Interim-Interval
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[87]
|
NAS-Port-Id
|
✓
|
–
|
–
|
–
|
✓
|
–
|
|
[88]
|
Framed-Pool
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[90]
|
Tunnel-Client-Auth-Id
(See Note 1.)
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[91]
|
Tunnel-Server-Auth-Id
(See Note 1.)
|
✓
|
✓
|
–
|
–
|
–
|
–
|
|
[96]
|
Framed-Interface-Id
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[97]
|
Framed-Ipv6-Prefix
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[99]
|
Framed-Ipv6-Route
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[101]
|
Error-Cause
|
–
|
–
|
–
|
–
|
✓
|
✓
|
|
[135]
|
Ascend-Primary-Dns
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[136]
|
Ascend-Secondary-Dns
|
–
|
✓
|
–
|
–
|
–
|
–
|
|
[188]
|
Ascend-Num-In-Multilink
|
✓
|
–
|
–
|
–
|
–
|
–
|
|
[242]
|
Ascend-Data-Filter
|
–
|
✓
|
–
|
–
|
–
|
–
|
[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
