HTTP Local Server Commands

This section describes the commands used to configure the HTTP local server application on the E-series router.

ip http

• Use to create the HTTP local server.
• Example

  host1(config)#ip http

• Use the no version to delete the HTTP local server.
• See ip http

ip http access-class

• Use to allow only subscribers on the specified standard IP access list to connect to the HTTP local server.
• Example

  host1(config)#ip http access-class chicagoList

• Use the no version to remove the association between the access list and the HTTP local server.
• See ip http access-class

ip http max-connection-time

• Use to specify the maximum time that the HTTP local server maintains an inactive connection.
• Specify a time in the range 3–7200 seconds, or 0. A value of 0 causes the server to maintain an inactive connection indefinitely.
• Example

  host1(config)#ip http max-connection-time 1000

• Use the no version to restore the default time, 30 seconds.
• See ip http max-connection-time

ip http port

• Use to specify the port on which the HTTP local server receives connection attempts.
• Specify a port number in the range 1–65535.
• Example

  host1(config)#ip http port 8080

• Use the no version to restore the default port number, 80.
• See ip http port

ip http redirectUrl

• Use to specify the URL to which a subscriber’s HTTP access session is redirected.
• The first access session is typically used by the Service Manager application to provide initial provisioning and service selection for the subscriber.
• HTTP redirect is per-interface; use the command in Profile Configuration mode for dynamic interfaces; use the command in Interface Configuration mode or Subinterface Configuration mode for static interfaces.
• The redirect URL can be a maximum of 64 characters.

  Note: The HTTP local server must be configured and enabled in the virtual router for the interface on which you use the ip http redirectUrl command. Otherwise, the URL redirect operation will fail.

• Example

  host1(config-if)#ip http redirectUrl http://ispsite.redirect.com

• Use the no version to restore the default, which disables the HTTP redirect feature.
• See ip http redirectUrl

ip http same-host-limit

• Use to specify the maximum number of connections that can exist between one IP address and the HTTP local server.
• Specify a number in the range 0–1000.
• Example

  host1(config)#ip http same-host-limit 20

• Use the no version to restore the default number of allowed connections, 3.
• See ip http same-host-limit

ip http server

• Use to enable the HTTP local server.
• Example

  host1(config)#ip http server

• Use the no version to disable the HTTP local server.
• See ip http server

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.