Configuring MDL Messages

You can configure a channelized T3 interface to send MDL messages. MDL messages are supported only when T3 framing uses C-bit parity, the default setting.

To configure a channelized T3 interface to send MDL messages:

1. Specify a T3 interface.

   host1(config)#controller t3 8/0

2. (Optional) Configure the interface to operate in an MDL carrier environment.

   host1(config-controll)#mdl carrier

3. Specify the MDL messages.

   host1(config-controll)#mdl string eic "ERX-1410"

   host1(config-controll)#mdl string fic "FG786"

   host1(config-controll)#mdl string lic "Bldg 10"

   host1(config-controll)#mdl string pfi "Site 25"

   host1(config-controll)#mdl string port 0800

   host1(config-controll)#mdl string unit 080001
   

4. Enable transmission of MDL messages.

   host1(config-controll)#mdl transmit path-id

   host1(config-controll)#mdl transmit idle-signal

   host1(config-controll)#mdl transmit test-signal

mdl carrier

• Use to specify that an interface is used in the carrier environment.
• Example

  host1(config-controll)#mdl carrier

• Use the no version to restore the default situation, in which the interface does not operate in the carrier environment.
• See mdl carrier.

mdl string

• Use to specify an MDL message.
• Example

  host1(config-controll)#mdl string port 0800

• Use the no version to restore the default value to the specified MDL message or to all MDL messages.
• See mdl string.

mdl transmit

• Use to enable transmission of MDL messages.
• Specify the keyword path-id to transmit path identifications every second.
• Specify the keyword idle-signal to send idle signals every second.
• Specify the keyword test-signal to transmit test signals every second.
• Example

  host1(config-controll)#mdl transmit test-signal

• Use the no version to disable transmission of the specified MDL message or all MDL messages.
• See mdl transmit.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.