Configuring a T3 or an E3 Controller

To configure a T3 or an E3 controller:

1. Select the T3 or E3 controller from Global Configuration mode.

   host1(config)#controller t3 3/2

2. Enable the T3 or E3 controller.

   host1(config-controll)#no shutdown

3. (CT3/T3-F0 line module only) Enable unchannelized operation for this controller.

   host1(config-controll)#no channelized

channelized

• Use to enable channelized T3 operation on an interface of a CT3/T3-F0 line module.
• Example

  host1(config-controll)#channelized

• Use the no version to enable unchannelized T3 operation on an interface for a CT3/T3-F0 line module.
• See channelized.

controller e3

• Use to specify an E3 controller in slot/port format.
  • slot—Number of the slot in which the line module resides in the chassis
  • port—Number of the port on the I/O module
• Example

  host1(config)#controller e3 3/2

• There is no no version.
• See controller e3.

controller t3

• Use to specify a T3 controller in slot/port format.
  • slot—Number of the slot in which the line module resides in the chassis
  • port—Number of the port on the I/O module
• Example

  host1(config)#controller t3 0/1

• There is no no version.
• See controller t3.

shutdown

• Use to disable a T3 or an E3 controller.
• The T3 or E3 interface is disabled by default.
• Example

  host1(config-controll)#shutdown

• Use the no version to restart a disabled interface.
• See shutdown.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.