Configuring a T3 Controller

To configure a T3 controller:

1. Access Controller Configuration mode by specifying the T3 controller.

   host1(config)#controller t3 0/1

2. Enable the T3 controller.

   T3 controllers are disabled by default.

   host1(config-controll)#no shutdown

controller t3

• Use to specify a T3 controller in slot/port format.
  • slot—Number of the slot in which the line module resides in the chassis
  • port—Number of the port on the I/O module
• Example

  host1(config)#controller t3 0/1

• There is no no version.
• See controller t3.

shutdown

• Use to disable a T3 controller.
• The T3 interface is disabled by default.
• Example

  host1(config-controll)#no shutdown

• Use the no version to restart a disabled interface.
• See shutdown.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.