[Contents] [Prev] [Next] [Index] [Report an Error]

Configuration Examples

To configure a T3 interface, start at the Global Configuration mode, and issue the following commands:



host1(config)#controller t3 0/1 

host1(config-controll)#no shutdwon 

host1(config-controll)#framing c-bit 

host1(config-controll)#clock source internal
module 

host1(config-controll)#cablelength 220 

host1#exit

To configure an E3 interface, use the controller e3 command in place of the controller t3 command.

To configure HDLC channels on a T3 serial interface, issue the following commands:



host1(config)#controller t3 10/0 

host1(config-controll)#exit 

host1(config)#interface serial 10/0 

host1(config-subif)#encapsulation ppp 

host1(config-subif)#ip address 192.32.10.2
255.255.255.0

To configure fractional T3 on an interface, issue the following commands:



host1(config)#controller t3 10/0 

host1(config-controll)#dsu mode 0 

host1(config-controll)#dsu bandwidth 10000 

host1(config-controll)#scramble

[Contents] [Prev] [Next] [Index] [Report an Error]