 |
Caution: Do not remove the SRP module while the system is running, unless you have properly issued the halt command. See JUNOSe System Basics Configuration Guide, Chapter 6, Managing Modules for information about the halt commands. |
An SRP module must be present for the router to boot. The routers support up to two redundant SRP modules operating in an active/standby configuration. The redundant SRP module takes control when a failover occurs. See Redundancy Features and the E120 and E320 Module Guide for more SRP module information.
|
Caution: Do not remove the SRP module while the system is running, unless you have properly issued the halt command. See JUNOSe System Basics Configuration Guide, Chapter 6, Managing Modules for information about the halt commands. |
 |
Note: You cannot use SRP modules of different capacities in the same configuration. For example, you cannot install a SRP-100 module and a SRP-320 module in the same router. |
For details about installing SRP modules, see Installing Modules.
 | Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |