Ground yourself by using an antistatic wrist
strap or other device and connect it to the ESD grounding jack on
the chassis.
With a Phillips screwdriver, loosen the captive
screws that secure the blank filler panel covering the empty chassis
slot, if present, and remove the filler panel.
Remove the SRP I/O module from its antistatic bag,
being careful not to touch module components, pins, leads, or solder
connections.
Slide the module into the chassis by placing it
between the guides of the selected slot and pushing the module until
it stops.
Note:
See the figures in ERX Overview for
module locations.
Tighten the module's captive screws using a Phillips
screwdriver. Turn both screws several times before tightening them
completely to allow the module to sit correctly.
