 |
Note: In the E-series documentation, the term ERX-7xx models refers to both the ERX-705 router and the ERX-710 router. The terms ERX-705 router and ERX-710 router refer to the specific models. See Figure 3 and Figure 4. |
|
Note: In the E-series documentation, the term ERX-7xx models refers to both the ERX-705 router and the ERX-710 router. The terms ERX-705 router and ERX-710 router refer to the specific models. See Figure 3 and Figure 4. |
The ERX-7xx models are robust, high-density routers with less capacity than the ERX-14xx models. The ERX-7xx models use either the SRP-10G module or the SRP-5G module.
You can configure the ERX-7xx models to enable the line modules (LM) to operate either at full line rate performance or at a rate dependent on the resources available. For information about configuring performance of line modules, see JUNOSe System Basics Configuration Guide, Chapter 6, Managing Modules.
|
Note: The 10-Gbps SRP module used in the ERX-310 router is different from the 10-Gbps SRP module used in the ERX-710 router. See SRP Module for more information. |
The ERX-705 chassis is the same as the ERX-710 chassis. (See Figure 3 and Figure 4.) The chassis contains seven slots to accommodate modules. Installation procedures and operating procedures are identical for both systems. All ERX-7xx and ERX-14xx models use the same SRP I/O module, but different power input modules are used.
|
Note: The router may look different from the routers shown in the figures in this chapter, depending on the line modules in the slots. |
Figure 3: ERX-7xx Models, Front View
Figure 4: ERX-7xx Models, Rear View
 | Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |