Navigation
Back up to About Overview
[+] Expand All
[-] Collapse All
- CTP2000 Series Hardware Guide
- Copyright and Trademark Information
- Table of Contents
- List of Figures
- List of Tables
- Overview
- CTP2000 Series Platform Overview
- CTP2000 Series Interface Modules
- CTP2000 Serial Interface Modules
- CTP2000 Multiservice Interface Module
- CTP2000 T1/E1 Interface Module
- CTP2000 Compression Module
- CTP2000 4WE&M Interface Module
- CTP2000 2W-FXS and 2W-FXO Interface Modules
- Required Cables and Pinouts
- Analog FXS/FXO Loop-Start Signaling
- Analog FXS/FXO Ground-Start Signaling
- Digital Signaling
- CTP2000 8P-IRIG Interface Module
- CTP2000 Clock Interface Modules
- Planning
- System Specifications
- Planning and Preparing the Site
- Equipment Rack Requirements
- Cable and Pinout Specifications
- CTP2000 4WE&M Interface Connector Pinouts
- CTP2000 FXS and FXO Interface Module Cables and Pinouts
- T1/E1 Interface Module Pinouts
- CTP2000 Serial Interface Module Pinouts
- CTP2000 Series Console Cable Pinouts
- CTP Fast Ethernet and Power Cables
- Safety
- General Safety Guidelines and Warnings
- Module Installation Safety Guidelines and Warnings
- Hardware Compliance
- Declaration of Conformity for CTP2000 Platforms
- Federal Communications Commission (FCC) Statement
- FCC Requirements for Consumer Products
- Food and Drug Administration, Center for Devices and Radiological Health
- Compliance with Canadian Regulations
- Industry Canada Notice
- Canadian Department of Communications Explanatory Notes
- Installation
- Unpacking and Inspecting the CTP Platform
- Installing the Chassis
- Installing Modules
- CTP2000 Modules Installation Overview
- Protecting CTP2000 Modules and Slots
- Required Tools and Safety Items for Installing CTP Modules
- Installing a CTP Interface Module, Processor Module, or Clock Module
- Removing a CTP Interface Module, Processor Module, or Clock Module
- Installing or Removing a CTP2000 Series CompactFlash Card
- Installing a PMC on CTP2000 Platforms
- Installing and Removing SFPs in a CTP Module
- Upgrading Components for Memory Upgrades
- Cabling
- Powering On
- Configuration
- Maintenance
- Maintaining Components
- Replacing Interface Modules Using Hot-Swap
- Product Reclamation and Recycling
- Replacing Fan Trays
- Packing and Returning Hardware
- Troubleshooting
- Troubleshooting Power Failures
- Contacting Customer Support
This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply.
