Navigation
Back up to About Overview
[+] Expand All
[-] Collapse All
A
C
- cabling
- fast Ethernet 1, 2
- overview
- power 1, 2
- recommendations
- required tools
- Case Manager, Juniper
- cleaning platform
- compliance, regulatory
- console See management console
- CTP overview
- CTP1002 platform 1
- CTP1004 platform 1
- CTP1012 platform 1
- CTPOS
- CTPView
- customer support 1
- contacting Juniper
- information needed
- locating serial numbers
- return procedure 1, 2
D
- damaged components, returning
- DB-25 connector 1, 2
- DB-9
- declaration of conformity, EC
E
H
I
- inspecting before installation
- installing
- interface modules
- pinouts See pinouts
J
M
- maintaining
- management console
- modules and components
P
- pinouts
- power
- powering off
- powering on 1, 2
- preinstallation responsibilities
R
S
T
- technical support
- troubleshooting power failures 1, 2
U
V
Download This Guide
Connecting Directly to the CTP1000 Platform
When you connect a console directly to the device, use the COM 2 port on the RJ-45 connector. To do this, you must use the special DB-9 adapter with a straight-through RJ-45 cable. Direct access through the COM 2 serial port enables you to monitor the device while it boots.
To connect a console directly to the device:
- Connect the female DB-9 connector to the COM 2 port on the device’s RTM.
- Connect the crossover adapter connector to your PC's serial port.
- Power on the device.
When you power on the device, the CLI appears on your console's screen. You can begin configuration. .
Related Documentation
- Setting Up Management Access on the CTP1000 Platform
- CTP1000 Console Port Setup
- Using HyperTerminal with the CTP1000 Platform
- CTP1000 Platform SSH Setup
