Paragon Planner Static Routes Overview
The Static Routes chapter describes how to view and modify static route tables. Static routes are used in IP networks and allow very precise control over traffic going through a router. By default, static routes take precedence over routing protocols such as RIP or OSPF to communicate routing information between routers. Static routes are ideal for small networks with a limited number of paths and are particularly well suited for peripheral routers that are connected to one or more networks via only one router. A disadvantage of static routes is its inability to adapt to router or link failures.
In Modify mode, the user may add, modify or delete any entry in any existing static route table. In all other modes, the user is allowed to view the entries of any existing static route table. Whether or not to use static routes is dependent on the type of network involved and the specific situation. General guidelines for using static routes are described above, and more information can be found in online tutorials and network design literature.
Prior to beginning this chapter, start up Paragon Planner and
open up a network (e.g., the
spec.mpls-fish specification file located in your
$WANDL_HOME/sample/IP/fish directory, where $WANDL_HOME is /u/wandl by default). You should
also have a general understanding of where and when to use static