Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Adding Primary Tunnels

To switch to modify mode, click on “Modify” mode button. The Modify pull-down menu gets activated.

Select Modify > Elements > Tunnels from the Modify pull-down menu. In the Tunnels window, click Add and select One Tunnel. The Add Tunnel window is displayed as shown in Figure 1.

Figure 1: Add Tunnel WindowAdd Tunnel Window

In the Properties tab, specify a TunnelID, the BW (bandwidth) for the tunnel, and the Pri,Pre (setup priority/holding priority) fields. Also select the source and destination nodes (Node A and Node Z).

In the Paths tab, Note the different ways of configuring a path under the To choose paths field.

Figure 2: Different Methods of Choosing PathsDifferent Methods of Choosing Paths

How to specify a configured and/or dynamic route is described later in this chapter.

After you have specified your route, click “Add” to add the tunnel. A yellow line between the source and destination will be drawn on the map to represent the logical tunnel. Note that the routing of the tunnel has not been performed yet.