Table 4 lists resolved issues in NorthStar Release 6.0.2.
Table 4: Resolved Issues in NorthStar Release 6.0.2.
Before performing a fresh install of NorthStar, you had
to use the
Cassandra password was reset to default for user cassandra.
Migrating IP addresses between links caused the links to be marked as failed.
NorthStar Planner showed incomplete device name in traffic file.
In NorthStar Planner, demand placement might route on incorrect link to destination when previous hop had non-direct static routes.
In NorthStar Planner Desktop application, CoS classes are not displayed in traffic charts.
Planner Desktop user sessions could remain in Active User table after disconnect.
System health update may not report when building process status where system configured to resolve username via remote nameservice and that nameservice is not responding.
Interfaces not seen under the nodes in the web UI.
Planner Traffic aggregation fails for runcodes other than x.
Network-Cleanup task was not deleting links in UNKNOWN state. It was only deleting links in DOWN state.
In NorthStar Planner, some ECMP paths through node chose Tunnel, some IGP. All should go to tunnel based on install or static route on transit node.
Creating a loop in the path of an SR LSP causes the operational status to be Down for the LSP.
NorthStar Planner web UI: If a user left the browser open without activity for a period of time, the session could be disconnected and be unable to fully resume later. As a result, some UI operations were not responding properly. The workaround was to use the close network menu option and reopen the network.
Bulk modification for Setup and Hold priority is not working.
Dashboard LSP Hop Count chart showed incorrect information.
Fresh install for analytics has connection refused error.
Core regression link update - unable to delete old link.
NorthStar cannot create an SR LSP with loose hops (user-specified ERO under Path tab in Provision LSP) when the routing method is "routeByDevice". This is resolved as long as you have Junos OS Release 19.1 or later. For earlier Junos OS releases, this functionality is not supported.
LDP Demand task now just specifies ECMP or not without explicitly providing number of ECMP paths to define.
Archive demands included a PATH/PR specification which could cause the demand to fail to be placed.
Netflow and LDP demands are now saved as ECMP without explicitly specifying a number of ECMP paths to consider. This allows the model’s general ECMP settings to be applied to these demands.
Setting of “Allow Any SID at first hop” behavior was reversed. Unsetting it allowed the SID list to not have to include first adjacency SID, and setting it enforced having first hop as an adjacency SID.
Desktop Planner metric optimization form missing New Z_A. Results tab now shows difference in new and old metric.
IGP metric was not sent after device collection in 6.0+. This does not concern TE metric which is learned dynamically.
With routing method set as ISIS, LSPs were being placed on links without ISIS protocol.
Bulk delete of LSPs was not working when the order consisted of PCE-initiated and PCC-controlled LSPs.
Planner may fail to open network archive with network with thousands of TE++ LSPs.