Configure LSP Delegation
Navigate to Applications > Configure LSP Delegation to reach the Configure LSP Delegation window where you can select LSPs to either delegate to NorthStar Controller or remove from delegation.
Figure 1 shows the Configure LSP Delegation window.
Click the check boxes for the desired LSPs on either the Add Delegation or Remove Delegation tab. You can also Check All or Uncheck All. Then click Submit at the bottom of the window.
When you add or remove delegation to/from the NorthStar Controller using this operation, the delegation statement block is added or removed from the router configuration.
This is not the same as the temporary removal you achieve when you right-click a tunnel in the network information table and select Return Delegation to PCC. In that case, control is temporarily returned back to the PCC for a period of time based on the router’s timer statement.
For IOS-XR devices, you must run device collection before doing any LSP delegation. This applies to LSPs that were manually created using the router CLI.