Platform and Software Compatibility
The NorthStar Controller 6.0.0 release is qualified to work with Junos OS Release 18.3R2.4. We recommend contacting JTAC for information about the compatibility of other Junos OS releases.Table 1 lists feature-specific Junos OS requirements. The NorthStar features listed have been qualified with the specified Junos OS release and are intended to work with that release.
Table 1: Feature-Specific Junos OS Requirements
Junos OS Release
Segment Routing (SPRING), MD5 authentication for PCEP, P2MP, Admin groups
PCEP-Provisioned P2MP Groups
PCEP-Provisioned P2MP Groups with MVPN (S,G) Service Mapping via Flowspec
Bandwidth sizing and container LSPs for SR-TE LSPs
PCC Delegated LSP Support for SR LSPs
The Path Computation Element Protocol (PCEP) configuration on the PCC routers does not persist across upgrades when the SDN package is not part of the installation binary. Before upgrading the Junos OS image to this release, save the existing configuration to a file by using the save command. After you upgrade the Junos OS image on each PCC router, use the load override command to restore the PCEP configuration.
The NorthStar Controller is supported on the following Juniper platforms: M Series, T Series, MX Series, PTX Series, and QFX10008. As of Junos OS Release 17.4R1, NorthStar Controller is also supported on QFX5110, QFX5100, and QFX5200. Please contact JTAC for more information.
Junos OS supports Internet draft draft-crabbe-pce-pce-initiated-lsp-03 for the stateful PCE-initiated LSP implementation (M Series, MX Series, PTX Series, T Series, and QFX Series).
There are three NorthStar Controller installation options for use with Junos VM as summarized in Figure 1.
You can also install NorthStar Controller using cRPD as summarized in Figure 2.
For installation procedures, see:
This topic also includes information about installing with NorthStar cRPD.