Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?


Adding One-Hop Tunnels


Using the one-hop tunnel feature, users can create a pair of one-hop tunnels for each link, one for each direction. These tunnels are created with an explicit route that force them to use the direct link.

The following commands are the corresponding Cisco commands for creating one-hop tunnels:

mpls traffic-eng auto-tunnel primary onehop
mpls traffic-eng auto-tunnel primary tunnel-num [min num] [max num]
mpls traffic-eng auto-tunnel primary config unnumbered-interface interface

The one-hop tunnel feature should only be used for networks where an IGP is deployed on the interfaces for which a one-hop tunnel will be created.

Select Modify > Elements > User Parameters. Click on the Tunnel tab. Then click “Add...” and add a user parameter to store the Tunnel Group ID, such as TunnelGroupID.

Figure 1: Adding a User Parameter for TunnelGroupID.
Adding a User Parameter for TunnelGroupID.

Select Modify > Elements > Tunnel ID Groups... In the selection menu, select the tunnel user parameter that was just created. Then click Add... to enter in a group name and ID range. The One Hop Tunnels you create will be given the group name as prefix and a number in the ID range as suffix.

Figure 2: Adding a Tunnel ID Group
Adding a Tunnel ID Group

Note that you can only add one-hop tunnels for links that have an IGP enabled. To enable an IGP protocol, modify the links through Modify > Elements > Links... and click the Modify button. In the Protocols tab turn on either OSPF or ISIS and click OK.

Figure 3: Enabling OSPF or ISIS on the Links
Enabling OSPF or ISIS on the Links

Select Modify > Elements >Tunnels, Add > One Hop Tunnels... Select some links by filtering for them. An easy way is to highlight them on the map and then click Filter from Map. Select the Tunnel ID Group to use to create the one hop tunnels and add a tunnel bandwidth. Click “OK” to add the one hop tunnels.

Figure 4: Add One Hop Tunnels
Add One Hop Tunnels

Select Modify > Elements > Tunnels to view the newly added one hop tunnels. Several nodes can have tunnels with the same TunnelID but different tunnels originating from a node should have unique tunnelIDs.

Figure 5: Results of One Hop Tunnel Additions
Results of One Hop Tunnel Additions

Note the explicit path given in the Configured column of the following table. Double-click on a newly added one-hop tunnel to view the configured route. Then select the User Parameters tab. The tunnel user parameter for Tunnel ID Group is specified here.

To generate configlets for these one hop tunnels, switch to Tunnel Layer and Design mode and then select Design > Configlets/Delta > LSP Configlet... Click “Submit” in the resulting window. The configlet includes in the description line the interface name used for the first hop of the tunnel.