Understanding the Topology View Tasks pane
The Tasks pane in Topology View contains all the tasks you can do in the Topology View. Click a specific task to begin that task.
Not all tasks are available in the Topology View. As you change your selections in the Topology map pane, the tasks in the Tasks pane also change—that is, some tasks such as Show Device Connectivity and Show QFabric Connectivity are available only after you select a device or a QFabric device, and Alarm tasks are available only after you select a site, building, floor, closet, or device.
Topology View tasks are divided into the following categories in the Tasks pane.
- Key Tasks—The most preferred tasks that you want to do while using the topology view. You can add important tasks from the topology task menu and hence the Key Tasks are a duplicate of select tasks from the Topology and Location tasks menu.
- Topology—The tasks you do to create the topology of your network.
- Location—The tasks you do to create a location such as a site, building, floor, closet, aisle, rack, and outdoor area.
- Alarm—The tasks that enable you to monitor the fault alarm details of the devices.
Table 1 describes the topology view tasks.
Table 1: Topology View Tasks
Task | Description |
|---|---|
Key Tasks | A duplicate of the most important tasks from other tasks menu. You can add your frequently used tasks to the key tasks menu. |
Topology: Displays the device discovery tasks | |
Show Device Connectivity | Displays the connection details of a device with its neighbors in graphical and grid views. If the selected device is connected to more than 60 devices, then the connection details are displayed only in grid view. |
Show QFabric Connectivity | Displays the dataplane connectivity details between the Interconnects and Nodes. |
Refresh Discovery | Refreshes the devices discovered and managed by Network Director earlier from Build mode. This task also refreshes the device connectivity. |
View Topology Discovery Job | Displays the discovery jobs in the topology view pane. |
Location: Displays the location related tasks | |
Setup Locations | Creates a new location. This task has sub tasks to add sites, buildings, floors, outdoor area, and closets. Note: You cannot create aisles and racks from Topology View. You must create the aisles and racks from the Location View work flow. |
Add Site | Creates a new site in Location view. Note: Use this task only to create the site object. Buildings, floors, closets, and outdoor areas in the site must be created separately. |
Add Building | Creates a new building in the selected site. Note: Use this task only to create the building. Floors and closets in the building must be created separately. |
Add Outdoor Area | Creates a new outdoor area in the selected site. |
Upload Floor Plans | Enables you to upload a floor plan for a floor in a building, if you already have a floor plan. |
Upload map | Enables you to upload a map to an outdoor area. |
Delete Site/Edit Site | Deletes or modifies the selected site. |
Alarm: Displays the alarm related tasks | |
Show Alarms by Severity | Displays the fault alarm details sorted based on the severity, that is from critical, major, minor, and info. |
Show Alarms By Category | Displays the fault alarm details sorted based on the category, that is from active, acknowledged, and cleared. |
Show Alarms By State | Displays the fault alarm details sorted based on the state, that is from active, acknowledged, and cleared. |
Show Current Active Alarms | Displays any active alarm that has not yet been cleared. |
