Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
What should I Do If I Do Not See Any Data in the Monitoring and Fault Modes?
If you face such a scenario, you must restart the jboss service that runs in Junos Space. Do the following to stop and start the jboss service:
- Log in to the Junos Space system console.
- When the console displays the Junos Space Appliance Settings menu, enter the number corresponding to the run shell option at the prompt.
- Type the password and press Enter.
- At the shell prompt, type the following commands sequentially
and press enter after each command:
[root@space]#service jmp-watchdog stop[root@space]#service jboss stop[root@space]#service jboss start[root@space]#service jmp-watchdog start
Junos Space restarts. This might take a few minutes. After Junos Space restarts, you can log in to Network Director and continue working in Monitoring and Fault modes.
