About the IKE (Phase I) Page
You are here: VPN > IKE (Phase I).
Use this page to configure IPsec VPN IKE (phase I).
Tasks You Can Perform
You can perform the following tasks from this page:
Add a gateway. See Add a Gateway.
Add an IPsec policy. See Add an IPsec Policy.
Add a proposal. See Add a Proposal.
Edit an IKE (Phase I) configuration. See Edit an IKE (Phase I) Configuration.
Delete an IKE (Phase I) configuration. See Delete IKE (Phase I) Configuration.
Launch VPN wizard. To do this, click Launch Wizard available on the upper right corner of the IKE (Phase I) table. Follow the guided steps to configure the VPN wizard.
Table 1 describes the fields on the IKE (Phase I) Configuration page.
Table 1: Fields on the IKE (Phase I) Configuration Page
Displays the name of the gateway to be searched.
Displays the text box for searching a gateway.
Displays the name of the destination peer gateway, specified as an alphanumeric string.
Displays the name of the IKE policy.
Displays the name of the interface to be used to send traffic to the IPsec VPN.
Displays information about the remote peer.
Displays the version of the IKE policy.
Displays the name of the policy.
Provides a description of the policy.
Displays the mode of configuration.
Displays the authentication method configured.
Displays the name of the proposal configured to be used by this policy in Phase 1.
Displays the name of the proposal selected.
Displays the hash algorithm configured or selected.
Displays the authentication method selected.
Displays the supported IKE proposals.