About the Static Page
You are here: Network > NAT > Static.
Use tis page to configure static NAT.
Tasks You Can Perform
You can perform the following tasks from this page:
Add a static rule set and rules to it. See Add a Static Rule Set.
Edit a static rule set and its rules. See Edit a Static Rule Set.
Delete a static rule set and its rules. See Delete Static Rule Set.
Launch NAT wizard. To do this, click Launch Wizard option at the right side of the page. The NAT wizard leads you through the basic required steps to configure NAT for the SRX Series security device.
Move the rules in the rules table. To do this, select a rule which you want to move and select the following options according to your choice:
Move Up—Enables you to move the rule up in the list.
Move Down—Enables you to move the rule down in the list.
Move to Top—Enables you to move the rule to top of the list
Move to Bottom—Enables you to move the rule to the bottom of the list
Table 1 describes the fields on the Static page.
Table 1: Fields on the Static Page
|Static NAT Rule Set|
Displays the destination NAT sort options from which the packets flow.
The options available are:
Displays the filter options.
Displays the name of the static NAT rule set.
Displays the name of the routing instance, zone, or interface from which the packets flow.
Displays the name of the rule in the selected static NAT rule set.
Displays a description of the static NAT rule set.
|Rules in Selected Rule-Set|
Displays the name of the routing instance, zone, or interface to which the packet flows.
Displays the source address to match the rule.
Displays the source port number.
Displays the destination address to match the rule.
Displays the destination port number.
Displays the static IP address prefix.
Displays the destination port or port range to allow static NAT to map ports.
Displays the upper threshold value of the at which an SNMP trap is triggered.
Displays the lower threshold value of the at which an SNMP trap is triggered.
Displays the description of the rule in the selected static NAT rule set.