Help Center User GuideGetting Started
 
X
User Guide
Getting Started
Contents  

Add a Static Rule Set

You are here: Network > NAT > Static.

Procedure

To add a static rule set:

  1. Click the add icon (+) on the upper right side of the Static page.

    The Add Rule Set page appears.

  2. Complete the configuration according to the guidelines provided in Table 203.
  3. Click OK to save the changes. If you want to discard your changes, click Cancel.

Table 203: Fields on the Add Static Rule Set Page

Field

Action

Rule Set Name

Enter a rule set name.

Rule Set Description

Enter a description for the rule set.

From

Select a filter option from the list:

  • Routing Instance

  • Zone

  • Interface

Select the routing instances, zones, or interfaces in the Available column and use the right arrow to move them to the Selected column.

Rules

Rules

Specifies the rules added to the selected static rule set.

Add

Procedure

To add a rule to the selected static rule set:

  1. Click + available at the upper right of the Rules table.

    The Add Rule page appears.

  2. Enter the following details:
    • Rule Name—Enter a rule name.

    • Rule Description—Enter a description for the rule.

    • Match—Displays the match destination address.

      • Source Address—Select an IPv4 or IPv6 address from the list or enter the address and click + to add it.

        Select an existing IPv4 or IPv6 address and click X to delete it.

      • Source Port—Enter a port number or port range from low to high and click + to add it.

        Port Range: 0 through 65535.

        Select an existing port and click X to delete it.

      • Destination Address—Select IPv4 or IPv6 and then select an address from the list.

      • Destination Port—Select one of the following options:

        • Any—Selects available port.

        • Port—Enter a port number.

        • Port Range—Enter a port range from low to high.

    • Then—Enter the following details:

      • Host Address—Enter the static prefix address.

        Note: You can select Translate to ipv4 address if you have selected IPv6 in the destination address.

      • Mapped Port—Select one of the following options:

        • Any—Selects available port.

        • Port—Enter a port number.

        • Port Range—Enter a port range from low to high.

      • Routing Instance—Select a routing instance from the list.

      • Upper Threshold—Enter an upper threshold value at which an SNMP trap is triggered.

        Range: 1 through 4294967295.

      • Lower Threshold—Enter a lower threshold value at which an SNMP trap is triggered.

        Range: 1 through 4294967295.

        Note: This option can be set only if you configure the upper threshold value.

  3. Click OK to save the changes. If you want to discard your changes, click Cancel.

Edit

Select an existing rule and click the edit icon at the top right corner of the Rules table.

The Edit Interface page appears with editable fields.

Delete

Select an interface and click the delete icon at the top right corner of the Rules table.

A confirmation window appears. Click Yes to delete the selected interface or click No to discard.

Related Documentation

Help us to improve. Rate this article.
Feedback Received. Thank You!

Ask questions in TechWiki

Check documentation in TechLibrary

Rating by you:      
X

Additional Comments

800 characters remaining

May we contact you if necessary?

Name:
Email:

Need product assistance? Contact Juniper Support

Submit