Monitor Chassis Alarm

About Chassis Alarm Page

You are here: Device Administration > Alarm Management > Chassis Alarm.

You can create a chassis alarm definition by selecting various options such as DS1, Ethernet, and integrated service, and so on.

Create Chassis Alarm Definition

Procedure

1. Enter the information specified in Table 156 to create Chassis Alarm Definition.

   Table 156: Chassis Alarm Definition Options

   Chassis Component	Alarm Configuration Option
   DS1	Alarm indicator signal (ais) Yellow alarm (ylw) Select an alarm condition from the list for DS1: Ignore Red Yellow None
   Ethernet	Link is down (link-down) Select an alarm condition from the list for Ethernet: Ignore Red Yellow None
   Integrated Services	Hardware or software failure (failure) Select an alarm condition from the list for Integrated Services: Ignore Red Yellow None
   Management Ethernet	Link is down (link-down) Select a alarm condition from the list for Management Ethernet: Ignore Red Yellow None
   Optical Transport Network Optical channel Data Unit (OTN ODU)	Backward defect indication (odu-bdi) Payload type mismatch (odu-ptim) Trail trace identifier mismatch (odu-ttim) Select a alarm condition from the list for OTN ODU: Ignore Red Yellow None
   Optical Transport Network Optical channel Transport Unit (OTN OTU)	Loss of frame (oc-lof) Loss of multiframe (oc-lom) Loss of signal (oc-los) Backward defect indication (oc-bdi) Forward error correction excessive FEC errors (out-fec-excessive-errs) Incoming alignment error (out-iae) Trail trace identifier mismatch (out-ttim) Wavelength-Lock (Wavelength Lock) Select a alarm condition from the list for OTN OTU: Ignore Red Yellow None
   Serial	Clear-to-send (CTS) signal absent (cts-absent) Data carrier detect (DCD) signal absent (dcd-absent) Data set ready (DSR) signal absent (dsr absent) Loss of receive clock (loss-of-rx-clock) Loss of transmit clock (loss-of-tx-clock) Select an alarm condition from the list for Serial: Ignore Red Yellow None
   Services	Services module hardware down (hw-down) Services link down (linkdown) Services module held in reset (pic-hold-reset) Services module reset (pic-reset) Receive errors (rx-errors) Services module software down (sw-down) Transmit errors (tx-errors) Select an alarm condition from the list for Services: Ignore Red Yellow None
   DS3	Alarm indication signal (ais) Excessive number of zeros (exz) Far-end receive failure (ferf) Idle alarm (idle) Line code violation (lcv) Loss of frame (lof) Loss of signal (los) Phase-locked loop out of lock (pll) Yellow alarm (ylw) Select an alarm condition from the list for DS3: Ignore Red Yellow None

2. Click OK to create Chassis Alarm Definition.

   The Chassis Alarm Definition page appears.

3. Click Cancel to cancel your entries and returns to the Chassis Alarm Definition page.

Edit Chassis Alarm Definition

Procedure

1. Click the pencil icon on the upper right side of the Chassis Alarm Definition page.

   See Table 156 for the options available for editing the Chassis Alarm Definition page.

2. Click OK.