Monitor Application Tracking
You are here: Monitor > Security Services > Application Tracking.
Use this page to monitor sessions and bytes of a particular application or group of applications.
Table 1 describes the fields on the Application Tracking page.
Table 1: Fields on the Application Tracking Page
Displays the risk as critical, moderate, low, or unsafe. The risk factor is based on the predefined security standard.
Note: Risk is displayed only for applications.
Displays the name of the application or application group.
Displays the number of active sessions.
Displays the application or application group traffic in kilobytes.
Displays the session percentage of the current application or application groups.
Displays the traffic percentage of the application or application groups.
Refers to the statistics that are collected from the last clearing time specified to the current time.
Enables you to set an interval of time during which statistics are collected.
You can specify the time interval in minutes, hours, or days. The default is 1 minute.
For example, if you set 5 minutes as the time interval at 13:00 hours, then statistics are collected from 13:00 to 13:05.
Time Interval Began
If Cumulative is selected, this field displays the last reset time that was set.
If Time Interval is selected, this field displays the last interval that was set.
Displays the time elapsed since the last time interval began.
If Cumulative is selected, the cumulative statistics are cleared.
If Time Interval is selected, the statistics collected during the last specified interval are cleared.
You are prompted to confirm that you want to clear the statistics.
Switch to Grid
In the grid view, data is displayed in a table.
By default, application tracking statistics are displayed in the grid view.
Switch to Graphical
In the graphical view, data is displayed in a chart. The two types of charts supported are:
# Displayed—Enables you to set the number of applications or application groups to be displayed in the chart. The maximum number allowed is 10, and the default is 3.
Display order—Enables you to sort the application and application groups in ascending or descending order. By default, applications are displayed in descending order.
Display by—Enables you to filter the display of applications and application groups by the following:
Bar chart is the default.
Click Refresh Display to retrieve the most current data.
Enables you to set some additional options. You can set the following:
Enables you to collect application level statistics.
You can filter application or application group statistics by the following:
Enables you to collect application group statistics.
Add to Results
Adds the filtered results to the output.