You are here: Monitor > Interfaces > Ports.
Use this page to view general information about all physical and logical interfaces for a device.
J-Web also supports IOC4 line cards for SRX5000 line of devices. You can also view the sub-ports details configured on any or all ports of the SRX5K-IOC4-MRATE line card.
J-Web also supports Wi–Fi Mini-PIM for SRX320, SRX340, SRX345, and SRX550M devices. The physical interface for the Wi-Fi Mini-PIM uses the name wl-x/0/0, where x identifies the slot on the services gateway where the Mini-PIM is installed.
Table 1 describes the fields on the Ports page.
Table 1: Fields on the Ports Page
Starts or stops monitoring the selected interfaces.
Displays the interface name.
Displays whether the interface is enabled (Up) or disabled (Down).
Displays whether the interface is linked (Up) or not linked (Down).
Displays the IP address of the interface.
Displays whether the zone is an untrust zone or a trust zone.
Displays services that are enabled on the device, such as HTTP and SSH.
Displays protocols that are enabled on the device, such as BGP and IGMP.
Displays interface bandwidth utilization. Input rates are shown in bytes per second.
Displays interface bandwidth utilization. Output rates are shown in bytes per second.
Displays input and output error counters in the form of a bar chart.
Displays the number of broadcast, unicast, and multicast packet counters in the form of a pie chart. (Packet counter charts are supported only for interfaces that support MAC statistics).
Table 2 shows the options to change the Interface display on the Ports page.
Table 2: Options to change the Interface Display
Port for FPC
Controls the member for which information is displayed.
Displays input and output packet counters and error counters in the form of charts.
Displays the interface graphs in a separate pop-up window.
Displays extensive statistics about the selected interface, including its general status, traffic information, IP address, I/O errors, class-of-service data, and statistics.
Indicates the duration of time after which you want the data on the page to be refreshed.
Clears the statistics for the selected interface.
Alternatively, you can enter the following show commands in the CLI to view interface status and traffic statistics:
show interfaces terse
On SRX Series devices, on configuring identical IPs on a single interface, you will not see a warning message; instead, you will see a syslog message.
show interfaces detail
show interfaces extensive
show interfaces interface-name