About the Ports Page
You are here: Network > Connectivity > Ports.
Use this page to view or configure the logical interfaces to switch to L2 or L3 mode. You can view the interfaces in the ways of interface type, interface state, or zone association.
Tasks You Can Perform
You can perform the following tasks from this page:
Add a logical interface. See Add a Logical Interface.
Edit a logical interface. See Edit a Logical Interface.
Delete a logical interface. See Delete Logical Interface.
Table 1 describes the fields to view interface configuration on the ports page.
J-Web also supports IOC4 line cards for SRX5000 line of devices. You can also view the sub-ports details configured on any or all ports of the SRX5K-IOC4-MRATE line card.
J-Web also supports Wi–Fi Mini-PIM for SRX320, SRX340, SRX345, and SRX550M devices. The physical interface for the Wi-Fi Mini-PIM uses the name wl-x/0/0, where x identifies the slot on the services gateway where the Mini-PIM is installed.
You can also configure the wl-x/0/0 interface when adding a zone at Security Policies & Objects > Zones/Screens.
Table 1: View Interface Configuration Details on the Ports Page
Select an option from the list to view the interfaces configuration details. The available options are:
Displays the list of interfaces based on the interface type, interface state, or zone association that you have used to filter the interface information.
Clears the filter options that you have selected and displays all the interfaces.
Expands the tree under the list of interfaces.
To configure global setting for the interface ports:
Disables the selected interface.
Enables the selected disabled interface.
Table 2 describes the fields on the ports page.
Table 2: Fields on the Ports Page
Displays the interface name.
Logical interfaces configured under this interface appear in a collapsible list under the physical interface.
Displays the administrative status of the interface. Status can be either Up or Down.
Displays the operational status of the link. Status can be either Up or Down.
Displays the configured IP addresses.
Multiple IP addresses configured on one logical interface are displayed in a collapsible list under the logical interface.
Displays the security zone with which this interface is associated.
Display the statistics information for the specified logical system or tenant.
Displays the maximum transmission unit value for this physical interface.
Displays the Interface speed (10 Mbps, 100 Mbps, 1 Gbps, or Auto).
Displays the link mode status for this interface. Status can be Active, Passive, or None.
Displays the auto negotiation status of the interface. Status can be either Enabled or Disabled.
Displays the media type of the operating modes (copper or fiber) for the 2-Port 10 Gigabit Ethernet XPIM.