Help Center User GuideGetting Started
 
X
User Guide
Getting Started
Contents  

Edit an IPsec VPN

You are here: Configure > Security Services > VPN > IPsec VPN.

Procedure

To edit IPsec VPN:

Note 

  • When the IKE status is up and if you edit the IPsec VPN, the topology diagram is shown in green.

  • All local gateway protected networks will form traffic selectors with all remote gateway protected networks and vice-versa.

  1. Select an existing IPsec VPN configuration that you want to edit on the IPsec VPN page.
  2. Click the pencil icon available on the upper right side of the page.

    The Edit IPsec VPN page appears with editable fields. For more information on the options, see Create an IPsec VPN.

  3. Click OK to save the changes. If you want to discard your changes, click Cancel.

Note 

  • You cannot edit the IPsec VPN unless it is a site-to-site VPN.

  • During edit, Auto-create Firewall Policy and Gateway behind NAT options are not supported.

  • When the routing mode is Traffic Selector, the traffic selector creates the complete mesh between the local and remote addresses.

Related Documentation

Help us to improve. Rate this article.
Feedback Received. Thank You!

Ask questions in TechWiki

Check documentation in TechLibrary

Rating by you:      
X

Additional Comments

800 characters remaining

May we contact you if necessary?

Name:
Email:

Need product assistance? Contact Juniper Support

Submit