Help Center User GuideGetting Started
User Guide
Getting Started

Monitor Cluster Status

You are here: Monitor > Device > Cluster Status.

Use this page to view the information of cluster status.

Table 47 provides the Cluster Status details.

Table 47: Cluster Status



Refresh Interval (sec)

Displays the time interval set for page refresh.

Select the time interval from the list.


Displays the option to refresh the page.

Cluster Status

Redundancy Group

Displays the redundancy group specified for the chassis cluster.


Displays the failover options selected.

  • Counter—Displays the number of times chassis cluster failed.

  • Action—Displays the active tool for users to fail over chassis cluster.


Displays the node used for the chassis cluster.


Provides an option to switch between the primary and secondary nodes.


Displays the state of the redundancy group for node 0 and node 1. The possible states are:

  • Primary—Redundancy group is active and passing traffic.

  • Secondary—Redundancy group is passive and not passing traffic.

  • Lost—Node loses contact with the other node through the control link. Most likely to occur when both nodes are in a cluster one node is rebooted, or, because of a control link failure, one node cannot exchange heartbeats with the other node.

  • Unavailable—Node has not received a single heartbeat over the control link from the other node since the other node booted up. Most likely to occur when one node boots up before the other node or if only one node is present in the cluster.


Displays the preempt option selected to initiate a failover for node 0 and 1. The possible preempt options are:

  • Yes—Mastership can be preempted based on priority.

  • No—Mastership cannot be preempted if the priority changes.

Manual Failover

Displays the priority value of node 0 for manual failover. The possible manual failover options are:

  • Yes—If the mastership is set manually, it overrides the Priority and Preempt options.

  • No—Mastership is not set manually.

Interface Monitoring


Displays the interfaces monitored by the redundancy group and shows their respective weights.


Displays the weight for the interface to be monitored.


Displays the status of the interface.

Related Documentation

Help us to improve. Rate this article.
Feedback Received. Thank You!

Ask questions in TechWiki

Check documentation in TechLibrary

Rating by you:      

Additional Comments

800 characters remaining

May we contact you if necessary?


Need product assistance? Contact Juniper Support